Siemens SINUMERIK 828D Commissioning Manual page 1060

Programming commands
6.3 Functions
Parameter:
Example
//M(TestGC/"Code generation:")
DEF VAR1 = (R//1)
DEF VAR2 = (R//2)
DEF D_NAME
LOAD
VAR1 = 123
VAR2 = -6
END_LOAD
OUTPUT(CODE1)
"Cycle123(" VAR1 "," VAR2 ")"
"M30"
END_OUTPUT
PRESS(VS1)
D_NAME = "\MPF.DIR\MESSEN.MPF"
GC("CODE1",D_NAME)
END_PRESS
130
Identifier Name of the OUTPUT method from which code is generated
Target file Path name of target file for HMI or NC file system
If the target file is not specified (only possible within Program‐
ming Support), the code will be written to the location of the
cursor within the file that is currently open.
Opt Option for generating comments.
0: (Default setting) Generate code with comment for the purpose
of recompilability (see also Recompile (Page 146)).
1: Do not create comments in the generated code.
Note: This code cannot be recompiled (see also Auto-Hot‐
spot).
Append This parameter is only relevant if a target file is specified.
0: (Default setting) If the file already exists, the old content is
deleted.
1: If the file already exists, the new code is written at the start of
the file.
2: If the file already exists, the new code is written at the end of
the file.
; Write NC code from the OUTPUT method to file
\MPF.DIR\MESSEN.MPF:
Cycle123(123, -6)
M30
SINUMERIK Integrate Run MyScreens
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3