Standardized Program And Data Management (From Sw 6.3); Manage Data - Siemens SINUMERIK 840D Operator's Manual

Hmi advanced

Hide thumbs Also See for SINUMERIK 840D:

Table of Contents

"Services" Operating Area

7.6.1 Standardized program and data management (from SW 6.3)

In the "Manage data" window in software version SW 6.3 and higher,

it is possible to manage workpieces, part programs, subprograms,

standard cycles, user cycles and manufacturer cycles with the same

number of softkey actuations as in the main Program window.

This standardized operating sequence applies to the following

applications:

· Creating new directories and programs

· Loading programs and files to the program memory

· Loading programs and files from the program memory to the hard

disk (unloading the program memory)

· Creating new files

· Copying and pasting files

· Deletion operations

Horizontal softkeys

Main screen in operating area

Directories/workpieces/

Programs/files

Manage programs:

SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition

Main screen in operating area

Data/files/comments

Definitions/part programs

Manage data:

Table of Contents

Sinumerik 840di Sinumerik 810d