Siemens SINUMERIK 840D Operator's Manual page 183

5
03.04
Tool wear:
fine compensation
Tool
offset
R
variables
Setting
data
Zero
offset
User
data
Determine
compens...
T No.
+
T No.
–
D No.
+
D No.
–
Delete...
Go to...
Overview...
New ...
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
If you have at least the authorization which is entered in MD 9202:
USER_CLASS_TOA_WEAR, you can change the values of the tool
fine offset incrementally. The difference between the old and new
values must not exceed the limit stored in MD 9450:
WRITE_TOA_FINE_LIMIT.
Horizontal softkeys
You can select different data types with the horizontal softkeys:
Selection of "Tool offset" menu
Selection of "R variables" menu
Selection of "Setting data" menu
Selection of "Zero offset" menu
Selection of "User data" menu
Support in determining tool offsets. This softkey is not required if the
tool management function is available.
Vertical softkeys
The vertical softkeys support data input:
Selection of the next tool
Selection of the previous tool
Selection of next higher offset number (cutting edge)
Selection of next lower offset number (cutting edge)
Deletion of a tool or cutting edge
Find any tool or the active tool
List of all available tools
New cutting edge or a new tool
"Parameters" Operating Area
5.2 Tool offsets
5
5-183