Spindle Data - Siemens SINUMERIK 840D Operator's Manual

5
"Parameters" Operating Area
5.5 Setting data

5.5.3 Spindle data

Max./min.
Programmed
Setting
data
Spindle
data
5-236
Change JOG data:
Position the cursor bar on the appropriate input field and enter a new
value or
select a new value using the "Select" key.
Other information
The limit values for the maximum and minimum permissible values
are defined in the machine data.
Function
The value entered for the spindle speed in the fields max./min. must
be within the limit values defined in the machine data.
Programmable upper speed limit (G96) for constant cutting speed.
Operating sequence
Select softkey "Setting data".
The vertical softkey bar changes.
Select softkey "Spindle data".
The "Spindle data - limitation" window opens.
Change spindle data:
Position the cursor bar on the appropriate input field and enter a new
value or
select a new value using the "Select" key.
Other information
· The limit values for the maximum and minimum permissible values
are defined in the machine data.
· The "Spindle data" function is displayed only if a spindle is
configured.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved