Siemens SINUMERIK 840D Operator's Manual page 315

6
03.04
Front Half
view section
or
Side Full
view section
or
Wire Wire
model model
or
Face
end
Periph.
surface
Menu "Details...." standard
vertical
Tool paths Tool paths
on/off on/off
or
Fit to
size
Zoom...
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
ditto
ditto
ditto
ditto
ditto
· "Top view" or "top view and front view" for
milling
· "Wire-frame model" (3D without tool data) for milling
· All views for turning
Activate/deactivate representation of the tool center point path.
Deactivation also deletes any tool paths from the current model that
have already been stored (default setting: tool paths on).
With 2 window views only: Select active window
Possible in the same manner with "TAB"- or "NEXT WINDOW (from
V06.02.13).
Front
Conditionally with 2 window views:
view...
"from front..." depending on type of view active (horizontal selection)
same meaning as "from above..." or "from left..."
Conditionally with 2 window views:
Rear
view...
"from behind..." depending on type of view active (horizontal
selection) same meaning as "from below..." or "from right..."
Automatic screen resizing
relative to the window activated with
Also possible with "ENTER" or "INPUT" key.
Show window pane border in active window
(Size can be altered with "+" - and "-" keys, position can be altered
with cursor keys.)
"Program" Operating Area
6.9 Program simulation
.
6
6-315