Siemens SINUMERIK 840D Operator's Manual page 317

6
03.04
Menu "Details...." alarms
vertical
End
simulation
Details
view...
<<
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Assuming an alarm status during simulation,
independent of the view currently active
Reset POWER ON alarms of simulation. The simulation is terminated
and loaded again.
Reset RESET alarms of simulation. The simulation interpreter is reset.
The simulation can be started again.
Reset CANCEL alarms of simulation. The simulation can be
continued.
The simulation process is terminated. A load operation is necessary
before the simulation is selected again.
Open the menu bar corresponding to the active workpiece view
"Details..." (standard or 3D) from the alarm state. The simulation
alarms remain active.
Return to main simulation menu
Additional note
1. Simulation alarms are only messages of the simulation
interpreter and have no direct association with the current
NCK machining status on the machine tool.
2. If more than one simulation alarm is pending, you can show or hide
the complete alarm list with the "toggle" key. You can select an
alarm with the cursor keys.
3. If you press the information key "i" the online help with an
explanation of the selected alarm is displayed.
4. Program sequences which cannot be interpreted in simulation
contexts only and only then trigger an alarm (e.g. in user cycles
because the relevant PLC data and signals are not available in the
simulation interpreter), must be jumped conditionally in the
corresponding NC program with evaluation of system variable
$P_SIM during the simulation (..IF $P_SIM GOTOF label). The
components relevant to simulation (e.g. tool change position and M
switching functions for tool change in tool change cycles, etc.
cannot be skipped, they must be executed.
5. The simulation does not evaluate events set by MD 20108, which
lead to program activation.
"Program" Operating Area
6.9 Program simulation
6
6-317