Siemens SINUMERIK 840D Operator's Manual page 398

7
"Services" Operating Area
7.7 Start-up functions
MMC data
selection
RS-232
PG
Diskette...
Archives
NC card
Read start-
up archive
RS-232
PG
Diskette...
Archives
NC card
Start
Make start-
up archive
7-398
Example:
Based on the original archive name MMCNCPLC, the new archive
name MMCNCPLC is suggested when you select PLC.
If you have selected the "MMC" area, you can select the data you
wish to archive by pressing softkey "MMC data selection". "MMC data
selection" stands for "HMI data selection".
The directory F:\USER is always backed up. Directories \ADD_ON
and \OEM can be saved additionally under "Additional products",
either completely ("Complete") or just the INI files ("Configuration").
The archiving operation commences when you select the target
device.
Archive data to:
·
The device connected to the RS-232 interface
· Programming device/PC
· Floppy disk drive
· "Archives" directory on hard disk
· "Archives" directory on the NC card
·
The softkey label changes to "Stop".
The series start-up archive is created.
Toggle between functions "Create series start-up archive" and "Read
start-up archive".
Reading series start-up archive:
The read-in operation commences when you select the source device
connected to the RS-232 interface. The data can be read via:
·
A device connected to the RS-232 interface
·
A programming device
·
The diskette drive
·
The "Archives" directory on the hard disk
·
The "Archives" directory on the NC card
·
Select an archive file under softkeys "Diskette", "Archives"
and "NC card".
·
Start reading in the archive. The softkey label changes to "Stop".
Switchover from "Read" to "Make".
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
7
03.04
Ó Siemens AG, 2004. All rights reserved