Copy Workpieces With Job Lists; Archive Workpieces With Job Lists In Case Of M:n - Siemens SINUMERIK 840D Operator's Manual

2
Operator Components/Sequence of Operations
2.8 Job list

2.8.6 Copy workpieces with job lists

Manage
programs
Copy
Insert
OK

2.8.7 Archive workpieces with job lists in case of m:n

Data
from
2-88
This function applies to operating area "Program" only.
When you copy under "Services", the names remain unchanged.
Operating sequence
The softkey "Manage programs" in the "Program" operating area must
be pressed.
Position the cursor on the file that you want to copy and press the
softkey "Copy".
The file is marked as the source for copying.
Press the softkey "Insert", specify another name if required
and confirm with "OK".
Function
When archiving workpieces that contain job lists of the same name, in
the case of m:n you are asked whether the job lists to be unloaded
are to be executed. You can terminate the action with "Cancel",
otherwise all joblists are executed and archiving is then started.
Operating sequence
In the "Services" operating area press the "Data from" softkey. The
"Programs/Data" file tree is displayed.
The vertical softkey bar changes.
Please refer to Chapter "Reading out data" in "Services" operating
area for additional sequences of operation.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
2
03.04
n
Ó Siemens AG, 2004. All rights reserved