Siemens SINUMERIK 840D Operator's Manual page 314

6
"Program" Operating Area
6.9 Program simulation
or
or
Details...
Settings
or
Note
Menu "Details...." standard
Horizontal
Milling turning
Top External
view view
or
6-314
Milling: Default top view
and front view
(free selection under "Details...")
Milling: 3D view
or wire model
Select status-dependent detail menu (active view, alarm status)
Select user and vendor-specific setting menus
in RESET or STOP state
or
in RUN state display current simulation override
1. On simulation START and program change, any 3D view currently
displayed is automatically deselected and replaced by a
technology-specific default view.
2. If you repeat machining simulation START after end of program
M2/M30 of the last program to be simulated, the simulation
channels are usually RESET and the simulation graphic reset if no
machining list has been activated with softkey "Channel/Spindle".
3. If the machining list under "Channel/spindle" is activated, the
overlay principle takes effect for the listed programs, where global
reset in combination with a simulation START is only activated
after a query on the last M2/M30.
4. New selection or reselection of one of the listed workpiece views is
implicitly linked to automatic screen size adjustment.
5. With the technology "turning", drills and milling tools in the
G19 plane can only be displayed as polymarkers (cross
symbol) in the side views. Only the tool center point path
without the tool body is displayed. The tool track is visible on
the front face view (G17) or on peripheral surface processing
(G19).
Assuming 2 window views with no alarm status:
· "Top view and front view" as default for milling
· "Half section and wire-frame model" as default for turning.
With 2 window views only:
Free selection of the different views in window activated by means of
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Turning: Full section, frontal
Turning: Default half-section, frontal
Front and wire model
(free selection under
"Details...")
Ó Siemens AG, 2004. All rights reserved
6
03.04