Full Standard Keyboard - Siemens SINUMERIK 840D Operator's Manual

Hmi advanced

Hide thumbs Also See for SINUMERIK 840D:

Table of Contents

Operator Components/Sequence of Operations

2.1 Operator panels

2.1.6 Full standard keyboard

Softkey assignment

Hardkey assignment

A full standard keyboard can be connected. However, a machine

control panel is required in addition to this keyboard.

The special function keys of the operator keyboard can also be used

with the full PC keyboard. The following table shows how the

horizontal and vertical softkeys and the special keys for the operator

panels are mapped onto the PC keyboard keys:

The following table shows how the hardkeys of the MF II keyboard on

the PC are mapped onto the keys for the operator panels:

The full standard keyboard does not meet the requirements (EMC) of

a SINUMERIK control. For this reason it can be used only for

installation and service purposes.

For further information about the configuration of operating keys,

please see: /IAM/, IM4 Installation and Start-Up, Chapter 5

Functions/Parameters.

SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition

Table of Contents

Sinumerik 840di Sinumerik 810d