Siemens SINUMERIK 840D Operator's Manual page 208

5
"Parameters" Operating Area
5.3 Tool management
5-208
When this softkey is pressed, a display appears where grinding data
can be:
· Display
· Modified
This display contains the following:
Top section:
- Tool name
- Duplo number
- Type,
- Cutting edge navigation bar
as in the "Cutting edge data" display for tool details
(The data is only displayed and cannot be modified)
Middle section:
The data correspond to the system variables entered for grinding.
Variable for
Spindle number
Chaining rule
Minimum wheel radius
Minimum wheel width
Current wheel width
Maximum speed
Maximum peripheral speed
Angle of inclined wheel
Parameter number for radius
calculation/compensation
parameter for GWPS
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Unit Names
- $TC_TPG1
- $TC_TPG2
[mm, in] $TC_TPG3
[mm, in] $TC_TPG4
[mm, in] $TC_TPG5
[rpm] $TC_TPG6
[m/s, ft/s] $TC_TPG7
[degrees] $TC_TPG8
- $TC_TPG9
Ó Siemens AG, 2004. All rights reserved
5
03.04