Siemens SINUMERIK 840D Operator's Manual page 222

5
"Parameters" Operating Area
5.3 Tool management
Display/Edit tool data
Offsets
Cut. edge
user data
Tool user
data
Abort
OK
5-222
The vertical softkeys can be used to display and edit the data for tools
already stored in the cabinet:
· Tool offset data (cutting edge data)
Enter the required offset values. The design of the vertical softkeys
is identical to the tool catalog softkeys (see previous section under
offsets).
A new cutting edge can be added to a tool at any time (even if the tool
is already located in the magazine).
· Cutting edge user data (if configured)
Up to 10 user-specific cutting edge data entries are displayed here.
Enter the required settings in the table.
· Tool user data (if configured)
Up to 10 user-specific tool data entries are displayed here. Enter
the required settings in the table.
· Select "Abort" to discard the settings.
The data retain their old values.
· Press "OK" to accept the changes.
The data are updated.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved