Siemens SINUMERIK 840D Operator's Manual page 221

5
03.04
Tool ma-
nagement
Tool
cabinet
Create tool offset
data
Abort
OK
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Operating sequence
Select softkey "Tool management".
The horizontal and vertical softkey bars change.
The horizontal softkey bar is expanded.
Select softkey "Tool cabinet".
The vertical softkey bar changes again.
In order to add a tool to the tool cabinet, it must first be created in the
tool catalog.
You create a real tool by defining a new Duplo number in the tool
cabinet.
Please proceed as follows:
· Select the desired technology, tool type and tool successively in
the appropriate list fields.
· Define the Duplo number.
The tool master data are loaded into the tool cabinet. The editing
functions are available.
· Use the vertical softkeys to make all the necessary changes to the
cutting edge data and user data.
· Select "Abort" to discard the settings.
The tool is not created.
· Select "OK" to save the changes.
The tool is created with the current offset data.
The defined tool data can be edited at any time. You can overwrite the
data for the current tool or allocate a new Duplo number to create a
replacement tool.
"Parameters" Operating Area
5.3 Tool management
5
5-221