Example Of A Job List With Two-Channel 1:1 Connections - Siemens SINUMERIK 840D Operator's Manual

2
03.04

2.8.2 Example of a job list with two-channel 1:1 connections

Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
COPY /SPF.DIR/PART1.* CG=MILL2
(Copies all files with one name from one directory e.g.
PART1.* from subroutines (SPF.DIR) to one channel group,
i.e. in all NCs which have channels of this group
assigned to them)
COPY /MPF.DIR/* CH=CHANNEL22
(Copies all files from one directory, e.g. all files from part
programs (MPF.DIR) to the NC which is assigned this
channel.)
Example
If only channel1 and channel2 on NCU1 (1:1 link) were involved in
machining of the workpiece, then the most suitable job list structure
would be as follows:
LOAD /MPF.DIR/Gen.MPF
LOAD /WCS.DIR/Part1.WPD/WpdGen.MPF
LOAD /WCS.DIR/Part1.WPD/ Channel1.MPF
LOAD /WCS.DIR/Part1.WPD/ Channel1.INI
LOAD /WCS.DIR/Part1.WPD/ K12.MPF
LOAD /WCS.DIR/Part1.WPD/ Channel2.MPF
LOAD /WCS.DIR/Part1.WPD/ Channel2.INI
LOAD /WCS.DIR/Part1.WPD/ K22.MPF
SELECT /WCS.DIR/Part1.WPD/Channel1.MPF CH=1
SELECT /WCS.DIR/Part1.WPD/Channel2.MPF CH=2
The destination is not specified for loading in a 1:1 link, the current NC
is the default.
Operator Components/Sequence of Operations
2.8 Job list
2
2-83