Other Types Of Setting Data - Siemens SINUMERIK 840D Operator's Manual

5
03.04

5.5.6 Other types of setting data

Setting
data
Misc.
General
SD
Channel-
specific SD
Axis-
specific SD
Find
Find next
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Function
All the setting data in the control are displayed in tabular form sorted
according to general (i.e. NCK-specific), channel-specific and axis-
specific setting data. The table contains both the setting data on the
vertical softkeys such as working area limitation, Jog data etc., as well
as special setting data such as software cam, oscillation, compensa-
tion etc.
Operating sequence
Select softkey "Setting data".
The vertical softkey bar changes.
Display setting data:
Select softkey "Misc.".
The horizontal and vertical softkey bars change.
Select the type:
·
The window "General setting data ($SN_)" appears.
·
The window "Channel-specific setting data ($SC_)" appears.
·
The window "Axis-specific setting data ($SA_)" appears.
The current setting data of the corresponding type $SN_, $SC_or
$SA_ are displayed.
You can page up and down using the "Page" keys.
Find setting data:
Enter the setting data you wish to find in the "Find" window (initial ID
is sufficient).
If several setting data have the same initial identifier, you can display
other setting data by selecting softkey "Find next".
Change setting data:
Position the cursor bar on the appropriate input field and enter a new
value.
"Parameters" Operating Area
5.5 Setting data
5
5-239