Unload - Siemens SINUMERIK 840D Operator's Manual

5
"Parameters" Operating Area
5.3 Tool management
Tool
list
Load
Find empty
location
Abort
Start

5.3.6 Unload

Tool ma-
nagement
5-214
Sequence of operations (loading from the "Tool list")
The "Tool list" is selected.
The appropriate tool is selected.
Press the "Load" softkey.
The vertical softkey bar changes.
Search for an empty location for a tool which has already been
created or enter the desired location and magazine number in the list.
The location found is entered under the magazine/location number.
The loading operation is not initiated.
The basic display appears.
The loading operation is initiated.
Function
This function allows you to unload a selected tool and to save its data.
Operating sequence
Select softkey "Tool management".
The "Magazine list" is displayed.
The horizontal and vertical softkey bars change.
You can unload a tool from the "Magazine list" or the "Tool list".
The sequence of operations is the same for both methods.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved