Siemens SINUMERIK 840D Operator's Manual page 82

2
Operator Components/Sequence of Operations
2.8 Job list
2-82
COPY [source] [destinationl]
The COPY instruction copies one or several files from the HMI to an
NC main memory. The original files remain stored on the MMC.
The COPY instruction is executed only if the relevant file does not yet
exist at the destination or if it has a different time stamp.
This instruction is recommended for an m:n link.
If this type of file needs to be modified, it must always be edited on the
NC. If the file has been distributed more than once via the job list, and
you want the changes to be active in all NCs, you must first unload
that file, then edit it, and finally redistribute it via the job list.
[source] is [path]/[name]
[destination] is the NCU/channel address:
The destination can be specified using one of the three address
categories. It must be noted that only the logical names from
NETNAMES.INI are taken into account.
NC= Name of NCU
Without NETNAMES.INI it is only possible to specify the NC
name with NC=.
CG= Name of the channel group, i.e. copy to each channel of this
group (therefore in all NCs the channels are assigned to).
Parameter CG can be specified only if a channel menu is
configured.
CH= Channel name
Channel names are only uniquely assigned across all NCs
if a channel menu is configured.
If no destination is specified, the source is copied to the NC currently
linked to the MMC. If * is entered as the target, the source is
distributed to all the NCs configured in NETNAMES.INI.
Examples:
COPY * *
(Copies all files from the workpiece of the job list to all NCs
that are configured in NETNAMES.INI)
COPY PART12.MPF NC=NCU_2
(Copies one file from the workpiece of the job list to the NC
"NCU_2")
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
2
03.04
Ó Siemens AG, 2004. All rights reserved