Siemens SINUMERIK 840D Operator's Manual page 318

6
"Program" Operating Area
6.9 Program simulation
Menu "Match data"
vertical
Loaded
data
Compare
setup data
Compare
tools
Compare
mach. data
Compare
cycles
<<
6-318
Correct password and NC components are prerequisite for using
Match data to load data selected in the NC to the simulation
environment. The data is then available for the simulated programs
just like during program execution in the NC.
(Matched data see data management \DP.DIR\SIM.DIR)
The loaded files are displayed.
User programs, user cycles, standard cycles, manufacturer cycles
and base data.
The selected data is loaded into the simulation environment from the
NC.
After modifying NC data, new data must be adapted if necessary.
On the other hand, the response of the NC to modified data can be
simulated in advance by modifying the data within the simulation
environment.
The tool data for all channels is loaded to the simulation environment
and copied to the file TO_INI.INI.
The machine data and active definition files are loaded to the
simulation environment and copied to the file INITIAL.INI.
The cycles which have already been loaded into the simulation are
replaced by cycles with more recent time stamps.
Return to main simulation menu.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
6
03.04
Ó Siemens AG, 2004. All rights reserved