Siemens SINUMERIK 840D Operator's Manual page 204

5
"Parameters" Operating Area
5.3 Tool management
Monitoring
data
Loc-dep.
offsets
Edge +
Edge –
Delete
edge
<<
5-204
The monitoring data of the currently selected cutting edge are
displayed and can be edited.
When you have selected a cutting edge, define the actual value,
setpoint and prewarning limit monitoring data for the following
parameters:
· Number of workpieces
· Tool life
· Wear
The tool offsets (identical to the cutting edge data table) and the
location-dependent offsets of the currently selected cutting edge are
displayed and can be edited.
You can change the following settings:
· Values can be defined for Length1, Length2, Length3 and Radius1
for each parameter.
· Up to six location-dependent offsets (DL1...DL6) are possible
(according to the machine manufacturer's configuration).
· Setup values and wear values can be defined for each offset.
In the individual tables, this softkey displays the data/offsets of the
next cutting edge for editing.
The data/offsets of the previous cutting edge are displayed and can
be edited.
In the table, select the cutting edge you want to delete (by positioning
the cursor).
The cutting edge is deleted when you activate the softkey.
Attention! There is no separate prompt.
The D number is removed from the table and can be reallocated.
Terminates input of the tool data and returns to the table displayed
previously.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved