Siemens SINUMERIK 840D Operator's Manual page 198

5
"Parameters" Operating Area
5.3 Tool management
Buffer
locations
Search and
position
Next
magazine
(Names assigned by
user)
Tool
list 1
Tool
list 2
Tool
list 3
Tool
details
Tool from
CC
5-198
Display and skip the buffer window in the magazine list. The display
shows spindles, grippers, etc., i.e. locations which can accommodate
tools but which are not magazine locations. If no intermediate memory
is defined, this key has no function.
The "Find tool/location" window appears.
· Search
- Tool:
Enter the tool name and Duplo number and start the search
with OK.
The cursor is positioned on the tool found.
- Location:
Enter the magazine and location number and start the search
with OK.
The cursor is positioned on the tool found.
· Positioning
Select softkey "Position", tool/location is moved to loading point. If
there is more than one possible loading point, a window is opened.
You can select the correct one with the cursor.
The locations of the next magazine are displayed in the magazine list.
You can only scroll forwards. When you reach the last magazine, the
display returns to the first magazine.
Vertical softkeys (tool list)
Selection of a table structure configured by the user
(if configured), e.g.:
· General data
· Geometry tool data
· Wear data
You can display and edit the complete data of a tool (as in the
magazine list).
The tool data are read from a code carrier and entered in the tool list
(you can then edit the data).
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
5
03.04
Ó Siemens AG, 2004. All rights reserved