Siemens SINUMERIK 840D Operator's Manual page 215

5
03.04
Magazine
list
Tool
list
Unload
Tool in
cabinet
Data on
CC
From
magazine
Delete
tool
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Select the appropriate list via softkey:
· "Magazine list"
A tool is to be physically removed from a magazine location. You
can configure whether the corresponding NC block is also
removed from the TO memory.
Select the magazine and the tool to be unloaded (select the tool
with the cursor).
or
· "Tool list"
The NC block is to be unloaded from the memory. Select the tool
to be unloaded (select the tool with the cursor).
Select softkey "Unload".
The vertical softkey bar changes.
The tool data of the selected tool are stored in the tool cabinet on the
hard disk. This allows you to load the tool with the same data again at
a later point.
If a code carrier is installed, the tool data are automatically stored
there. This allows you to load the tool with the same data again at a
later point.
The vertical softkey bar changes.
The corresponding line is deleted from the magazine list.
The entries in the magazine number and location number columns are
removed from the tool list.
"Unload directly from spindle" is possible only if the buffer is selected
and the cursor is positioned on the location of the spindle.
To exit the screen without unloading the tool, select another display
in the vertical softkey bar before activating "Start".
The tool data of the selected tool are deleted from the TO memory. If
the tool is in a magazine location, it is unloaded and deleted.
If a host computer is connected, the data are transferred to the host
computer each time a tool is deleted or unloaded.
"Parameters" Operating Area
5.3 Tool management
5
5-215