Siemens SINUMERIK 840D Operator's Manual page 381

7
03.04
Management
Display
New ...
Delete...
Assign...
Copy...
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
The vertical softkeys offer the following options:
The parameters of the selected RS-232 parameter file are displayed
in the "RS-232 interface" display. The file name is displayed in the title
bar of this screen form.
After entering the file name (maximum of 10 characters) the current
RS-232 parameters are written to a new file in the RS-232.DIR
directory.
The selected RS-232 parameter file is deleted after being confirmed
by the user. If a file that is assigned to an interface is deleted, the file
name is also removed from the softkeys for the interface.
As of SW 6.2: An RS-232 parameter file is assigned to the current
interface via a dialog box. The corresponding parameters are actively
set and the file name is displayed on the relevant softkeys (instead of
RS-232 or PG). The status bar indicates the parameters saved in the
file.
The current assigned interface can be changed temporarily using the
vertical softkeys.
1. a) The current RS-232 parameter file is copied to the
RS-232.DIR directory after entering a new name
(maximum of 10 characters).
b) Or is copied to a diskette by pressing the softkey "Diskette".
c) Or is copied to the clipboard by pressing the softkey
"Clipboard".
2. If several files are selected simultaneously, only copying to a
diskette or to the clipboard is active.
When copying to a diskette or to the clipboard, a new file name
cannot be specified.
"Services" Operating Area
7.5 Operation
7
7-381