Machine Data For The Tool Management; Settings For The Tool Management - Siemens SINUMERIK 828D Commissioning Manual

Tool management

9.3 Machine data for the tool management

9.3 Machine data for the tool management
9.3.1

Settings for the tool management

Machine data (default setting)
The following machine data has already been preset for tool management or will be set with
"default data" during booting: These settings can be changed as necessary.
MD number
10715[0]
10716[0]
10717
17500
20124
20270
20310
22550
22560
22562
MD20270: $MC_CUTTING_EDGE_DEFAULT
If no cutting edge is programmed after a tool change, the cutting edge number set in
$MC_CUTTING_EDGE_DEFAULT is used.
MD20270: $MC_CUTTING_EDGE_DEFAULT
272
Designation
M_NO_FCT_CYLE
M_NO_FCT_CYLCLE_NAME
T_NO_FCT_CYLCLE_NAME
MAXNUM_REPLACEMENT_TOOLS
TOOL_MANAGEMENT_TOOLHOLDER
CUTTING_EDGE_DEFAULT
TOOL_MANAGEMENT_MASK
TOOL_CHANGE_MODE
TOOL_CHANGE_MCODE
TOOL_CHANGE_ERROR_MODE
Basic setting of tool cutting edge without programming (DWORD)
> 0 Number of the cutting edge that is selected with M206 Cutting edge selection is also
active if followed by D programming.
= 1 Default setting
= 0 No cutting edge is initially active after a tool change. Any tool offset active before tool
change is deselected (corresponds to D0!). Cutting edge selection only active with D
programming.
= -1 Tool edge number of old tool also applies to new tool.
= -2 Tool edge offset of old tool remains active until D is programmed.
Value
6
L6
TCHANGE
0
1
1
181400F
180400F
0
1
206
0
Commissioning Manual, 02/2012, 6FC5397-3DP40-3BA0
(M version)
(M version)
(T version)
(T version)
(M version)
(T version)
(M version)
(for manual tool)
Turning and Milling