Restoring The Original State Via Nc Card - Siemens SINUMERIK 840D Operator's Manual

7
03.04
In software version 6.3
and higher

7.7.2 Restoring the original state via NC card

Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Other information
For importing a series start-up file from diskette, there must be
sufficient free hard disk memory to store the series start-up file.
If a control is configured for M:N (several operator panel fronts and
NCUs), a Power On must be initiated on the HMI (PCU 50) after a
series start-up so that the stations on the bus (NC, PLC, HMI) can be
re-synchronized.
Archiving loadable compile cycles (CC):
You can archive loadable compile cycles in the series machine start-
up if the following conditions are met:
· At least one CC must be available in the start-up archive in
destination directory \NC_CARD.DIR\CCOEM.DIR.
· Selective archiving of individual CC is performed by copying to
data medium, e.g. a diskette. Only archives with access
authorization for series machine start-up in access levels 0 to 4
can be read in.
Function
The free memory on the NC card (PCMCIA card) can be used to store
a start-up archive.
The archive can be loaded onto the NC card with SINUCOPY-FFS
(on an external PG/PC).
The series start-up archive can be stored directly on the NC card from
the HMI with the name "Original" (see Series start-up - creating a file).
Operating sequence
Requirement:
The start-up archive with the name _N_ORIGINAL_ARC is located on
the NC card (in the directory _N_NC_CARD_DIR\_N_ARC_DIR).
Please read machine manufacturer's instructions
"Services" Operating Area
7.7 Start-up functions
7
7-399