Execute Job List" Operating Sequence - Siemens SINUMERIK 840D Operator's Manual

2
03.04

2.8.4 "Execute job list" operating sequence

Manage
data
Load
Selection
Unload
Load
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
E.g. press the softkey "Manage data" under "Services".
The horizontal and vertical softkey bars change.
Position the cursor on the correct workpiece directory.
Then execute functions
· "Load"
· "Selection"
· "Unload"
from.
If a job list named Workpiece.JOB is stored in a workpiece
directory, then the functions are executed for that job list.
However, the functions can be executed directly on the job list, e.g. if
the directory contains job lists that are named differently from the
workpiece.
Other Information
"Load" job list
"Load" means that all the prepared job list instructions are executed.
The data is distributed from [Source] to [Destination], to the
destination NCs with the instruction LOAD or COPY. The workpiece is
then marked as "loaded".
SELECT instructions are ignored.
If the workpiece/job list is loaded, then the log window displays a list
of the files to be distributed.
The log window can be displayed in the event of an error. Loading of
the job list can then be aborted if necessary.
Marking of files on user interface
If the file is stored only on the hard disk of the HMI, then it is marked
as "not loaded".
If the file is only located in the RAM of the NC, it is marked as loaded
with an "X".
If the file is located both in the HMI and in the NC, the identifier "X" is
only removed when the files are no longer identical.
If the files have different time stamps or are of different lengths, the
identifier is "!X!".
Operator Components/Sequence of Operations
2.8 Job list
2
2-85