Changes from cycle version SW4.4 and higher
A.2 Changes in the machine and setting data from SW 4.4
A.2
Changes in the machine and setting data from SW 4.4
MD replaced with SD
The following cycle machine data (measuring in JOG) no longer apply from cycle release SW
04.04.01 (compared to SW 02.06.00 ) and are replaced by the following cycle setting data that
mean the same .
MDs are no longer required
51609 $MNS_MEA_INPUT_TOOL_PROBE_SUB[0 .. 5]
51755 $MNS_J_MEA_MEASURING_FEED
51774 $MNS_J_MEA_T_PROBE_TYPE[n]
51776 $MNS_J_MEA_T_PROBE_ALLOW_AX_DIR[n]
51778 $MNS_J_MEA_T_PROBE_DIAM_LENGTH[n]
51782 $MNS_J_MEA_T_PROBE_T_EDGE_DIST[n]
51787 $MNS_J_MEA_T_PROBE_MEASURE_FEED
Change, number of the setting data
For the following cycle setting data, from SW 04.04.01, the number of the setting data changes
(with respect to cycle release SW 02.06.00). Identifier and function have not changed.
Release SW 02.06.00 From SW 04.04.01
54798
54799
55630
55631
55632
55633
348
Number SD
54780
54782
55632
55634
55636
55638
Replaced by SD
54652 $SNS_MEA_INPUT_TOOL_PROBE_SUB[0 .. 5]
55630 $SCS_MEA_FEED_MEASURE
54633 $SNS_MEA_TP_TYPE[n]
54632 $SNS_MEA_TP_AX_DIR_AUTO_CAL[n]
54631 $SNS_MEA_TP_EDGE_DISK_SIZE[n]
54634 $SNS_MEA_TP_CAL_MEASURE_DEPTH[n]
55628 $SCS_MEA_TP_FEED_MEASURE
Identifier
$SNS_J_MEA_FUNCTION_MASK_PIECE
$SNS_J_MEA_FUNCTION_MASK_TOOL
$SCS_MEA_FEED_RAPID_IN_PERCENT
$SCS_MEA_FEED_PLANE_VALUE
$SCS_MEA_FEED_FEEDAX_VALUE
$SCS_MEA_FEED_FAST_MEASURE
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles