Displaying Nc System Resources - Siemens SINUMERIK 840D Operator's Manual

8
"Diagnosis" Operating Area

8.6 Displaying NC system resources

8.6 Displaying NC system resources
Diagnosis
Service
displays
System
resources
NC
Stop
Start
8-434
Function
For the NC areas you can display the system resources (utilization
display) currently being used:
Net and gross runtimes of
· position controller,
· interpolator and
· preprocessing.
Operating sequence
The "Diagnosis" operating area is selected.
Press softkey "Service displays" then "System resources:.
The "NC utilization" screen is displayed.
The following minimum/maximum total data for the servo, IPO cycle
and preprocessing are displayed:
· Net runtime in ms
· Gross runtime in ms
· Level of the IPO buffer in percent
· Total capacity utilization in percent
The display update can be halted with the softkey "Stop", the
displayed values are updated again with the softkey "Start".
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
8
03.04
n
Ó Siemens AG, 2004. All rights reserved