Siemens SINUMERIK 840D Operator's Manual page 430

8
"Diagnosis" Operating Area
8.4 PLC status
End
Details
Modified
Accept
Modified
Accept
8-430
Press this softkey to jump to the end of the symbol table.
All information is displayed for the selected address or symbol in the
following representation:
If relevant texts are available in the PLC project, they are displayed
here as "description".
You can change the value of the symbol that is currently displayed in
detail.
The input marker is positioned on Value. Value input is completed by
pressing the Enter key; however, the values are only activated when
the "Accept" softkey is pressed. You can also choose a more suitable
display format.
The entered value is transferred to the PLC interface.
You can change the value for the selected symbol. Value input is
completed by pressing the Enter key; however, the values are only
activated when the "Accept" softkey is pressed. You can also choose
a more suitable display format. Before pressing the Accept softkey to
validate the data changes, you can modify any number of symbol
values in sequence.
The previously entered values are transferred to the PLC interface.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
8
03.04
Ó Siemens AG, 2004. All rights reserved