Returning The Workstation To Service; Table 3-2 Customer-Replaceable Components And Service Procedures - Silicon Graphics Tezro Hardware User's Manual

Returning the Workstation to Service

007-4564-001
Customer-replaceable Components and Service Procedures (continued)
Table 3-2
Component
PCI and XIO Boards:
IO9 board
XIO boards
PCI boards
Fans:
Fan wall
Hard disk drive fan
Rear fan assembly
Internal Cables:
L1 display cable
LED cable
DVD-ROM drive cable
Enclosure Components:
Enclosure Bezel Assembly
Enclosure Side Plastics
Enclosure Top Plastics
L1 Controller Display
When you are finished installing or removing internal components, proceed to the next
section.
The following sections contain instructions for returning the workstation to service:
• "Installing the Bezel" on page 58
• "Installing the Side Panels" on page 60
• "Cabling and Powering on the Workstation" on page 61
Procedure
"Replacing the IO9 Board" on page 76
"Installing or Removing XIO Boards" on page 81
"Installing or Removing PCI Boards" on page 88
"Replacing the Fan Wall" on page 94
"Replacing the Hard Disk Drive Fan" on page 95
"Replacing the Rear Fan Assembly" on page 98
"Replacing the L1 Display Cable" on page 100
"Replacing the LED Cable" on page 103
"Replacing the DVD-ROM Drive Cable" on page 105
"Replacing the Bezel Assembly" on page 107
"Replacing the Side Plastics" on page 107
"Replacing the Top Plastics" on page 107
"Replacing the L1 Display" on page 108
Returning the Workstation to Service
57