Returning The System To Service; Installing The Enclosure Bezel - Silicon Graphics Prism Hardware User's Manual

3: Maintenance and Upgrade Procedures

Returning the System to Service

Installing the Enclosure Bezel

52
The following sections contain instructions for returning the system to service:
• "Installing the Enclosure Bezel" on page 52
• "Installing the Side Panels" on page 54
• "Cabling and Powering on the System" on page 55
Follow these instructions to install the bezel.
1. Align the tabs on the lower portion of the bezel with the holes in the enclosure.
2. Insert the tabs into the holes and press the bezel and door assembly against the
enclosure to ensure that it snaps into place and is properly seated.
3. Lift the bezel slightly if needed to align the screw holes with the mounting holes in
the enclosure. Then install the screws that secure the bezel to the enclosure.
007-4772-002