Thermo Scientific 42i Instruction Manual page 305

Thermo Fisher Scientific
set default params
This command sets all the parameters to their default values. This does not
affect the factory-calibrated parameters.
Send: set default params
Receive: set default params ok
ozonator
This command reports the ozonator is on or off. The example below
reports that the ozonator is on.
Send: ozonator
Receive: ozonator on
set ozonator onoff
These commands set the ozonator on or off. The example below sets the
ozonator off.
Send: set ozonator off
Receive: set ozonator off ok
ozonator flow
This command reports the current ozonator flow. The example below
reports that the current ozonator flow is 0.050 LPM.
Send: ozonator flow
Receive: ozonator flow 0.050 l/m
ozonator safety
This command reports the status of the ozonator safety on or off. The
example below reports that the ozonator safety is on.
Send: ozonator safety
Receive: ozonator safety on
set ozonator safety onoff
These commands set the ozonator safety on or off. The example below sets
the ozonator safety off.
Send: set ozonator safety off
Receive: set ozonator safety off ok
ozonator status
This command reports the status of the ozonator and safety. The example
below reports that the ozonator is off.
Send: ozonator status
Receive: ozonator status off
C-Link Protocol Commands
Hardware Configuration
Model 42i Instruction Manual B-41