Instrument State
Thermo Fisher Scientific
The Instrument State submenu allows the user to select the instrument
state that is assigned to the selected relay output. A submenu lists signal
types of either alarm or non-alarm to choose from.
In the Main Menu, choose Instrument Controls > I/O Configuration >
●
Output Relay Settings > Select Relay > Instrument State.
CHOOSE SIGNAL TYPE:
>ALARMS
NON-ALARM
RANGE
Alarms
The Alarms screen allows the user to select an alarm status for the selected
relay output. The currently selected item is shown by "<--" after it. The
I/O board status alarm is only present if the I/O expansion board is
installed. Zero and Span Check Cal are only present if the automated
zero/span check is enabled. See the Alarms Menu section later in this
chapter for more information on alarm items.
In the Main Menu, choose Instrument Controls > I/O Configuration >
●
Output Relay Settings > Select Relay > Instrument State > Alarms.
AVG
DIAGS ALARM
Operation
Instrument Controls Menu
Model 42i Instruction Manual
3-45