Thermo Scientific 42i Instruction Manual page 306

C-Link Protocol Commands
Hardware Configuration
B-42 Model 42i Instruction Manual
pmt status
This command reports the status of the PMT on or off. The example
below reports that the PMT is on.
Send: pmt status
Receive: pmt status on
set pmt onoff
These commands set the PMT on or off. The example below turns the
PMT off.
Send: set pmt off
Receive: set pmt off ok
save
set save params
This command stores all current parameters in FLASH memory. It is
important that each time instrument parameters are changed, that this
command be sent. If changes are not saved, they will be lost in the event of
a power failure. The example below saves the parameters to FLASH
memory.
Send: set save params
Receive: set save params ok
time
This command reports the current time (24-hour time). The example
below reports that the internal time is 2:15:30 pm.
Send: time
Receive: time 14:15:30
set time hh:mm:ss
hh = hours
mm = minutes
ss = seconds
This command sets the internal clock (24-hour time). The example below
sets the internal time to 2:15 pm.
Note If seconds are omitted, the seconds default to 00.
Send: set time 14:15
Receive: set time 14:15 ok
▲
Thermo Fisher Scientific