Table of Contents
Advertisement
4)
Click [Measure Stds] in the Calibration dialog box, to display the Measure Mechanical Standard dialog box.
5)
If the used calibration kit is different from the default calibration kit of Analyzer, click [Select CalKit] in the Measure
Mechanical Standard dialog box, to display the Select Calibration Kit dialog box and select the used calibration kit in the
box. Click [OK] to close the Select Calibration Kit dialog box.
6)
If it is required to set calibration standard, click [Select Std] in the Measure Mechanical Standard, to display the Type
Information dialog box, and click [OK] to close the Type Information after completing setting.
Figure 5-3 Selecting Calibration Type
Figure 5-4 Measure of Mechanical Standard Dialog Box
Figure 5-5 Selecting Calibration Kit
78
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com
Advertisement
Table of Contents
