Table of Contents
Advertisement
By front panel keys
1)
Press 【Trace】in TRACE/CHAN area and press the soft-key corresponding to [New Trace...] in soft-key menu displayed
on the right of screen to show New Trace dialog box.
2)
Press 【Tab】 in ADJUST area to switch to [More Type] button and press 【Click】to display New Trace dialog box.
3)
Press 【Tab】 in ADJUST area to switch to [Source] box and press 【↑】 and 【↓】 or rotate knob to select source output
port of Analyzer.
4)
Press 【Tab】 in ADJUST area to switch to [Scale Type] and press 【Click】to mark check box.
5)
Press 【Tab】 in ADJUST area to switch to Input zone and press 【↑】 and 【↓】 or rotate knob to select input receiver
of ratio Measure.
6)
Press 【Tab】 in ADJUST area to switch to Reference zone and press 【↑】 and 【↓】 or rotate knob to select reference
receiver of ratio Measure.
7)
Press [OK] in ENTRY area to close dialog box.
4.2.3. Non-ratio power Measure
The non-ratio power Measure parameter can measure the absolute power entering receivers (i.e. A, B, R1 and R2), but Measures of
phase and group delay and any other Measures enabling average functions cannot be performed.
Creating new non-ratio power Measure Trace
4.2.3.1.
By mouse or touch screen
1)
Single click [Trace/Chan], single click [New Trace...] in [Trace] menu, and display the dialog box of Create New Trace.
2)
Single click [More Type] button to display the dialog box of New Trace.
3)
Select the source output port of Analyzer from [Source] box.
4)
Click [Scale Type] to eliminate check box (if marked).
5)
Select Measure receiver of signals from Input zone.
6)
Single click [OK] button to close the dialog box after the setting is completed.
By front panel keys
1)
Press 【Trace 】 in TRACE/CHAN area and press the soft-key corresponding to [New Trace...] in the corresponding
soft-key menu to show New Trace dialog box.
2)
Press 【Tab】 in ADJUST area to switch to [More Type] button and press 【Click】 to display New Trace dialog box.
3)
Press 【Tab】 in ADJUST area to switch to [Source] box and press 【↑】 and 【↓】 or rotate knob to select source
output port of Analyzer.
4)
Press 【Tab】 in ADJUST area to switch to [Scale Type] and press 【Click】 to eliminate check box (if marked).
5)
Press 【Tab】 in ADJUST area to switch to Input zone and press 【↑】 and 【↓】 or rotate knob to select Measure
receiver of signals.
6)
Press 【OK】in ENTRY area to close dialog box.
Creating new Trace dialog box (arbitrary ratio and non-ratio power Measure)
4.2.3.2.
[Source]
Tel: 886.2.2175 2930 Email: sales@salukitec.com
37
www.salukitec.com
Advertisement
Table of Contents
