Saluki S3601 Series User Manual page 56

Trigger input zone

Global trigger delay zone

When external trigger signals are received, the Analyzer will start Sweep after the delay time as set in Time Delay dialog box.
Trigger source zone

It can be set that through which rear panel connector the Analyzer will receive trigger signals.
Level/edge zone

 High level
When the Analyzer is ready for triggering, it will trigger at the high level of the selected TTL input signal.
 Low level
When the Analyzer is ready for triggering, it will trigger at the low level of the selected TTL input signal.
 Positive edge
When the Analyzer is ready for triggering, it will trigger at the next rising edge of the received signal.
 Negative edge
When the Analyzer is ready for triggering, it will trigger at the next falling edge of the received signal.
Trigger output zone

Enable channel

When selected, it may trigger output.
Polarity zone

Set the polarity of trigger output.
Fig. 4-22 External Trigger Dialog Box
56
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com