Measure Ports; Rear Panel Tour - Saluki S3601 Series User Manual

The key 【On/Standby】 is only a standby switch that is not connected directly to the external power supply and can not cut off

connection of the analyzer with the external power supply. The external power supply to the analyzer can be disconnected with
the power switch on the rear panel. Removing the power cord can completely cut off connection of the analyzer with the
external power supply.

Measure Ports

3.1.12.
Measure ports of Analyzer are two type-N female ports, which can be switched between RF source and receiver to measure the
measured piece in two directions; yellow lamp is used to indicate current source output port.
The input damage level: RF power: +26dBm, DC voltage: ±30V.

The damage level limit of the analyzer is +26dBm RF power or ±30V DC voltage. The input exceeding the above range may burn
the instrument.

3.2.Rear Panel Tour

The rear panel of Analyzer is shown as the following figure:
Fig. 3-12 【On/Standby】Key and Indicator Light
Fig. 3-13 Measure Ports of the Analyzer
Fig. 3-14 Analyzer Rear Panel
23
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com