Table of Contents
Advertisement
This method can make a setting of Analyzer quickly in 4 steps:
a)
Press the corresponding utility keys of the front panel to Stimulus the soft-key toolbar of the item.
b)
Observe the function options of active project toolbar.
c)
Select required function based on the corresponding soft-key.
d)
Enter values (if necessary).
Use a Drop-down List
This method can use all functions of Analyzer, but the operation is relatively complicated and trivial, and the specific steps are as
below:
a)
Press 【Menu】 key to switch to the Menu/Dialog mode.
b)
Press the 【Tab】 keys and【↑】, 【↓】 keys to browse the menu; press the 【Click】 key to make a selection.
c)
Browse and set the dialog box through the【Tab】key (if the dialog box is open).
d)
Entry values (if necessary).
e)
Press the 【OK】in the ENTRY area to close the dialog box (if the dialog box is opened).
3.3.2. Mouse Interface
The following operations can be done by using mouse:
a)
Click on the menu bar to display the drop-down list.
b)
Click the existing item soft-key toolbar to select the function.
c)
Click the Measure toolbar to add Measure tracks.
Click the Control toolbar to control the sweep.
d)
e)
Click the Stimulus toolbar to set the Sweep excitation.
f)
Click the Marker toolbar to set the marker.
g)
Right click on the screen to display the right click menu.
Tel: 886.2.2175 2930 Email: sales@salukitec.com
27
www.salukitec.com
Advertisement
Table of Contents
