Table of Contents
Advertisement
5)
Press 【Tab】in ADJUST area to switch to [Enable User Reset State] and press 【Click】to mark check box.
6)
Press 【OK】in ENTRY area to close dialog box.
4.1.3. Reset Analyzer
By mouse or touch screen
Single click [Utility], and then single click [Preset] in the Utility menu.
By front panel keys
Press 【Preset】in UTILITY area.
4.2.Selecting Measure Parameter
We can set the Analyzer to use the following parameters to measure electrical properties of a device:
S parameter (fixed ratio)
Arbitrary ratio (Measure of user-defined ratio)
Measure of non-ratio power (absolute power Measure)
4.2.1. S parameter
Creating new S parameter Measure Trace
4.2.1.1.
By mouse or touch screen
1)
Single click [Trace], single click [New Trace...] in [New Trace] menu, and display the dialog box of New Create Trace.
2)
Select new S parameter Measure Trace to be created in the dialog box.
3)
Single click [OK] button to close the dialog box after the setting is completed.
Fig. 4-2 Resetting Analyzer
Fig. 4-3 Create New S Parameter Trace
35
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com
Advertisement
Table of Contents
