Transmission Measure In Band Pass Mode - Saluki S3601 Series User Manual

An example of reflection Measure in band pass mode is provided below:
There is a pulse at 0 point on time axis, which represents the first discontinuous point (connector) met from the measuring port

output.
The subsequent pulse represents the second discontinuous point (connector) met by impulse signal.


8.5.3. Transmission Measure in Band Pass Mode

Horizontal axis data:
It represents transmission delay when passing the measured piece.

Vertical axis data:
In the format of logarithm amplitude, it represents transmission loss or transmission gain.

In the format of linear amplitude, it represents transmission coefficient.

An example of surface filter (SAW) transmission Measure in band pass mode is provided below:
Three transmissions in surface acoustic wave (SAW) filter can be found from Measure results: the signal is reflected back to

input port by output port and then reflected back to output port again.
Pulse closest to 0 time point represents transmission time of the shortest path between input and output of the measured

piece; however, it is neither the maximum pulse definitely nor representing the expected transferring path.
Fig.8-15 Reflection Measure in Band Pass Mode
Fig.8-16 Transmission Measure in Band Pass Mode
133
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com