Table of Contents
Advertisement
6.7.Fixture Simulator
Fixture simulator could simulate various test conditions which are based on the test results during the manufacturing. It will make
quick and real-time simulation on the corresponding test result.
6.7.1. Reference impedance conversion of port
To converse the test result under 50Ω port impedance to the test results under any port reference impedance.
By mouse or touch screen
6.7.1.1.
1)
Click [Marker/Analysis] menu,click [Fixture Simulator] on the menu of [Analysis] and click [Fixture Simulator on/OFF]
on the sub-menu to open fixture simulator function.
2)
Click [Marker/Analysis] menu, click [Fixture Simulator] on the menu of [Analysis] and click [Z Conversion] on the
sub-menu to open impedance conversion dialog box.
3)
Click [On/Off (Z)] to enable impedance conversion function.
4)
Enter corresponding values in the editing box of the real part and imaginary part of the port1 and port2.
5)
Click [OK] to open the dialog box and save the input;click [Cancel] to close the dialog box and cancel the saving of
the input.
Figure 6-21 Ripple Test Result
105
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com
Advertisement
Table of Contents
