Window - Saluki S3601 Series User Manual

measured. All traces that are assigned to a channel share the same channel settings. A channel must be selected (active) to modify
its settings. When the traces in a channel are active, the channel is also active. The following are channel settings:
Frequency span

Power

Calibration data

IF bandwidth

Number of Points

Sweep Setup

Average

Trigger (some settings)


3.4.3. Window

Window is used to observe Measure traces. The analyzer supports up to 32 windows, with each window displaying up to eight traces.
Window and channel are completely independent. Through the [Response] menu, window display can be set.
Creating a new window

By mouse or touch screen

Click [Response] and in the drop-down list, click [Display]; select [New Window] in the [Windows], and the analyzer will create a
window, which is defaults for no traces.
By front panel keys

a) Press 【Display】 key in the RESPONSE area.
b) In the soft-key menu displayed on the right screen, press [Windows] corresponding soft-key to display the lower
soft-key menu.
c) Press [New Window] corresponding soft-key, and the analyzer will create a new window, which are defaults for no
traces.
Viewing a Window with the Full Screen View

When there are too many windows on the screen, the windows will be too small and the traces will not be clear; then the full screen
Fig. 3-25 Creating a New Window
29
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com