Table of Contents
Advertisement
The filter test function can only be set through soft-key menu.
1)
Press【Search】in MKR/ANALYSIS area, and press corresponding soft-key of [Bandwidth]
2)
on the soft-key menu that turns up.
3)
Press corresponding soft-key of [Tracking on|OFF] to enable track function.
4)
Press corresponding soft-key of [Filter Test] and press corresponding soft-key of [Filter Test
5)
on|OFF] to enable filter test function.
6)
Press corresponding soft-key of [BW1 Level] and set the level value of bandwidth1 in the input box.
7)
Press corresponding soft-key of [BW2 on|OFF] to enable bandwidth2 function.
8)
Press corresponding soft-key of [BW2 Level] and set the level value of bandwidth2 in the input box.
9)
Press corresponding soft-key of [Freq Offset] and set the value of frequeny difference percentage in the input box.
10) Press corresponding soft-key of [Filter Test ON|off] to close filter test function.
Display bandwidth searching result
6.5.3.2.
The eight parameters of filter test will be displayed on the upper left side of the trace. Enabling the filter test , the bandwith searching
function will be activated automatically and the six parameters of bandwidth test will be displayed on the upper right side of the trace.
6.6.Ripple Test
Ripple test can assess the test results through setting up fluctuation limit. It compares the test data with the defined fluctuation limit,
provides PASS and FAIL information and the test result will be displayed directly on the screen. Each trace supports 12 separated
limit segments at best. Each limit segment can be set with start stimulus, stop stimulus and maximum fluctuation value. The stimulus
Figure 6-18 Filter Test
101
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com
Advertisement
Table of Contents
