Table of Contents
Advertisement
Inverse:
Adjoint:
It means to conjugate on complex
Impedance of port X and port Y respectively.
When the impedance conversion function in the fixture simulator is enabled, the characteristic impedance of corresponding port is
the set value in the impedance conversion. Otherwise, use the system impedance
6.9.Setting Time Domain Transformation Measure
6.9.1. By mouse or touch screen
1)
Click [Marker/Analysis], click [Transform...] in submenu to display Time Domain Transform dialog box.
2)
Click to select [Transform] check box and Stimulus time domain transformation function.
3)
Click [Start], [Stop] or [Center], [Span] box to set time domain Measure range.
4)
Select transformation mode in Transformation Mode zone: [Low Pass Impulse], [Low Pass Step] or [Band Pass].
5)
Set Window function: click [Window] Selection Button in Time Domain Transform dialog box and set window filter with
three methods below:
Drag sliding box with mouse till pulse width or sidelobe level meets the requirement.
Click [Gaesarian Window β Para] to adjust setting of value β, till pulse width or sidelobe level meets the requirement.
Click [Pulse Span] to set response pulse width directly.
Z
t
s
1
1
2
Z
Z
0X
0Y
S
Z
Z
,in which,
and
0X
0Y
xy
Fig.6-27 Setting Time Domain Transformation Measure
Tel: 886.2.2175 2930 Email: sales@salukitec.com
S
xy
，
1
1
S
xy
Z
Z
0X
0Y
1
S
xy
represent the characteristic
Z
(default value is 50Ω).
0
111
1
Y
ts
Z
t
s
www.salukitec.com
Advertisement
Table of Contents
