Saluki S3601 Series User Manual page 68

Reference marker (used for the relative Measure)

stimulus value of marker

Response valve at the place of marker

Limit table
4.9.3.2.
The limit table is used to display and modify the limit test settings, and these settings contain:
Type of limit test (MAX, MIN or OFF)

Start and stop stimulus values of the limit line segment

Start and stop response values of the limit line segment

Display type of the limit line segment (SLOT, FLAT or POINT)

Segment table
4.9.3.3.
The segment table is used to set up and modify the segment Sweep, and these settings contain:
Segment condition (ON/OFF)

Start and stop stimulus values of the segment

Sweep spot number of the segment

Power level (each segment can be set up individually)

Intermediate-frequency bandwidth (each segment can be set up individually)

Sweep time (each segment can be set up individually)

Triggering of table display
4.9.3.4.
By mouse or touch screen

1) Click [Response], point at [Display] on the Response menu, and point at [Tables] on the display submenu.
2) Click the table to set up in the Tables submenu, enable the table display when checking, and close table display when
removing the tick.
Figure 4-34 Limit Table
Figure 4-35 Segment Table
68
Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com