Changing Measure Type Of Trace - Saluki S3601 Series User Manual

Select output port of Analyzer source signals.
[Scale Type]

Create new arbitrary ratio Measure Trace when it is checked a new non-ratio power Measure Trace during elimination.
[Input]

Select input receiver for measuring response signals of DUT.
[Reference]

Select reference receiver for performing ratio Measure.
[Ch Select]

It is used for selecting the channel for a new Trace.
[Create in New Window]

A Trace is created in a new window when it is checked and another one is created in current window during elimination.

4.2.4. Changing Measure Type of Trace

For Analyzer, if some Trace needs to be set and modified, the Trace must be changed to the current Active Trace, and then can be
modified.
Changing Stimulus state of Trace
4.2.4.1.
By mouse or touch screen

Single click Trace Status Bar on the upper part of window and the corresponding Trace becomes the current Active Trace.
By front panel keys

Press [Trace Prev] or [Trace Next] in TRACE/CHAN area. Or, the following operation methods can be employed:
Press 【 Trace 】 in TRACE/CHAN area and press the soft-key corresponding to [Select Trace] in the corresponding

soft-key menu to show Current Trace dialog box.
Press 【↑】 and 【↓】 in ADJUST area or rotate knob to select the Trace requiring to be Stimulus in Current Trace dialog

box.
Setting S parameter Measure type of current Active Trace
4.2.4.2.
By mouse or touch screen

1) Single click [Response] and point to [Measure] in Response menu to display submenu of Measure.
2) Single click S parameter Measure type to be selected from the submenu.
Fig. 4-5 Changing Stimulus State of Trace
Fig. 4-6 Setting S Parameter Measure Type of Current Active Trace
Tel: 886.2.2175 2930 Email: sales@salukitec.com
38
www.salukitec.com