Parameter Descriptions; Parameter Selection - Danfoss VLT AutomationDrive FC 301 Programming Manual

Parameter Descriptions

3 Parameter Descriptions

3.1 Parameter Selection

3 3
Parameters are organized in parameter groups for easy
selection of parameters.
0-** Operation and Display includes:
•
Basic settings, set-up handling.
•
Display and local control panel parameters for
selecting readouts, setting up selections, and
copying functions.
1-** Load and Motor includes all load and motor-related
parameters.
2-** Brake includes:
•
DC brake.
•
Dynamic brake (resistor brake).
•
Mechanical brake.
•
Overvoltage control.
3-** Reference / Ramps includes DigiPot function.
4-** Limits / Warnings includes setting of limits and
warning parameters.
5-** Digital In/Out includes relay controls.
6-** Analog In/Out.
7-** Controllers includes parameters for speed and process
controls.
8-** Comm. and Options includes parameters for setting of
RS485 and USB port parameters.
9-** PROFIdrive.
10-** CAN Fieldbus.
12-** Ethernet.
13-**Smart Logic.
14-** Special Functions.
15-** Drive Information.
16-** Data Readouts.
17-** Position Feedback.
28
®
VLT AutomationDrive FC 301/302
18-** Data Readouts 2.
30-** Special Features.
32-** MCO Basic Settings.
33-** MCO Adv. Settings.
34-** MCO Data Readouts.
35-** Sensor Input Option.
NOTICE
To see if a parameter can be used in a specific control
mode, use Table 4.3.
Danfoss A/S © 02/2016 All rights reserved. MG33ML02