Danfoss VLT AutomationDrive FC 301 Programming Manual page 174

Parameter Descriptions
15-72 Option in Slot B
Range:
0 [0 - 30] View the type code string for the option installed
*
3 3
15-73 Slot B Option SW Version
Range:
0 [0 - 20] View the software version for the option installed
*
15-74 Option in Slot C0/E0
Range:
0 [0 - 30] View the type code string for the option installed
*
15-75 Slot C0/E0 Option SW Version
Range:
0 [0 - 20] View the software version for the option installed
*
15-76 Option in Slot C1/E1
Range:
0 [0 - 30] Shows the type code string for the option in slot
*
15-77 Slot C1/E1 Option SW Version
Range:
0 [0 - 20] Shows the software version for the installed option
*
15-80 Fan Running Hours
Range:
0 h [0 - 2147483647
*
h]
15-81 Preset Fan Running Hours
Range:
0 h [0 - 99999
*
h]
172
Function:
in slot B, and a translation of the type code string.
For example, for type code string BX, the
translation is No option.
Function:
in slot B.
Function:
in slot C, and a translation of the type code string.
For example, for type code string CXXXX, the
translation is No option.
Function:
in slot C.
Function:
C1 (CXXXX if no option) and the translation, that is
No option.
Function:
in option slot C.
Function:
View how many hours the heat sink
fan has run (increments for each hour).
The value is saved when the frequency
converter is turned off.
Function:
Enter value to preset the fan running hours
counter, see parameter 15-80 Fan Running
Hours.
This parameter cannot be selected via the
serial port, RS485.
Danfoss A/S © 02/2016 All rights reserved.
®
VLT AutomationDrive FC 301/302
15-89 Configuration Change Counter
Range:
0 [0 - 65535]
*
3.16.7 15-9* Parameter Info
15-92 Defined Parameters
Range:
0 [0 - 9999 ] View a list of all defined parameters in the
*
15-93 Modified Parameters
Range:
0 [0 - 9999 ] View a list of the parameters that have been
*
15-98 Drive Identification
Range:
0 [0 - 40] This parameter contains data that is used by the
*
15-99 Parameter Metadata
Range:
0 [0 - 9999] This parameter contains data used by the MCT
*
Function:
NOTICE
This parameter cannot be adjusted while
the motor runs.
Function:
frequency converter. The list ends with 0.
Function:
changed from their default setting. The list ends
with 0. Changes may not be visible until up to
30 s after implementation.
Function:
MCT 10 Set-up Software.
Function:
10 Set-up Software.
MG33ML02