Parameters: 7-** Controllers - Danfoss VLT AutomationDrive FC 301 Programming Manual

Parameter Descriptions

3.9 Parameters: 7-** Controllers

3.9.1 7-0* Speed PID Ctrl.
NOTICE
3 3
If separate encoders are used (FC 302 only), adjust the
ramp-related parameters according to the gear ratio
between the 2 encoders.
7-00 Speed PID Feedback Source
Option:
[0] Motor feedb. P1-02
[1] 24V encoder
[2] MCB 102
[3] MCB 103
[4] MCO Encoder 1 X56
[5] MCO Encoder 2 X55
[6] Analog Input 53
[7] Analog Input 54
[8] Frequency input 29
[9] Frequency input 33
[11] MCB 15X
120
®
VLT AutomationDrive FC 301/302
Function:
NOTICE
This parameter cannot be
adjusted while the motor is
running.
Select the encoder for closed loop
feedback.
The feedback may come from a
different encoder (typically mounted
on the application itself ) than the
motor-mounted encoder feedback
selected in parameter 1-02 Flux Motor
Feedback Source.
Danfoss A/S © 02/2016 All rights reserved. MG33ML02