Table of Contents
Advertisement
1 - 16 ACCESSORIES
(5) Assemble solenoid valve " B " (three-way valve)
w i t h replacement O - r i n g seals.
(6) I n s t a l l t h e b a l l , s p r i n g and solenoid valve " B "
w i t h Tool J-25399 (Fig. 9).
(7) I n s t a l l the v a l v e block and the replacement O-
r i n g seals on the p u m p base.
(8) I n s t a l l the retainer, the spring, t h e b a l l , the i n -
sert valve and t h e p u m p housing w i t h
replacement
O - r i n g seals (Fig. 11). T i g h t e n the p u m p housing-to-
base n u t s w i t h 11.3 Nma (100 in-lbs) torque.
(9) I n s t a l l t h e f i l t e r s and t h e plugs w i t h replace-
m e n t O-ring seals (Fig. 9).
(10) I n s t a l l solenoid valve " A " cartridge
(two-way
valve) i n t h e p u m p base w i t h replacement
O-ring
seals (Fig. 9).
(11) I n s t a l l solenoid valve " A " coil (Fig. 9).
(12) I n s t a l l the motor on the p u m p h o u s i n g (Fig. 9).
Engage the gear shaft t a n g w i t h the notch i n the mo-
t o r o u t p u t shaft. T i g h t e n t h e motor-to-housing cap
screws w i t h 5 N»m (45 in-lbs) torque.
(13) I n s t a l l t h e r a m and piston w i t h replacement
O-ring seals (Fig. 9).
(14) Position t h e cover on the reservoir and secure
i t w i t h l o c k n u t s (Fig. 9). T i g h t e n t h e locknuts w i t h
11.3 N*m (100 in-lbs) torque.
POWER ANGLING
CYLINDER
SERVICE
I f a n g l i n g cylinder f l u i d leakage occurs (a s l i g h t
w e t t i n g i s n o r m a l ) , t h e cause could be a loose gland
n u t (Fig. 14). T i g h t e n the gland n u t .
CAUTION: Over-tightening the gland nut can "lock"
the cylinder. Leakage will not cease immediately be-
cause fluid has accumulated between the packing
and the gland nut. If the leakage persists after con-
tinued usage, replace the rod packing (Fig. 14).
' GLAND NUT
ROD PACKING
POWER ANGLING CYLINDER
WIPER PACKING
SPLIT BEARING
RN886
Fig. 14 Angling Cylinder—Exploded View
Advertisement
Table of Contents
